ClearOne MAX EX Spezifikationen PDF herunterladen (Seite 10)

6 Technical Services: 800.283.5936

PROVISIONING YOUR MAX IP PHONE

There are two methods available for configuring your MAX IP phone:

• The first method is manually, through the phone's keypad and a web portal associated with the phone.

• The second method provisions the phone automatically when it is plugged into the network. This method

uses a DHCP server to assign the phone minimal IP information so that it can access the network, includ-

ing an IP address, gateway, subnet mask, and TFTP server address. A TFTP server is then used to auto-

matically upload firmware (when new firmware is available) and provisioning information to the phone, so

that it is ready to make a call after it has completed the booting sequence.

By default, the MAX IP is configured for automatic provisioning and assumes the IT administrator has correctly

configured the DHCP and TFTP servers on the phone network. When more than a few phones are to be

provisioned, it is recommended that you use the automatic method, otherwise the manual method is the best.

CONFIGURING THE IP ADDRESS

Before any other provisioning can be done, you must first configure the host IP address and the subnet mask

of the MAX IP phone. These must be known in order to provision the phone through the web interface. These

settings are usually obtained automatically from the DHCP server, however, they can also be assigned manual-

ly if the host IP address is to be a static IP address.

CONFIGURING THE DHCP SERVER

When configuring a DHCP server for use with the MAX IP phone, the following parameters should be

assigned:

• IP address

• Subnet mask

• Gateway IP address

• TFTP server IP address

• DNS server IP address

• Secondary DNS server IP address

• DNS domain

The IP address and subnet masks are defined by DHCP option 1.

The Gateway IP address is defined by DHCP option 3.

The TFTP server is defined first by DHCP option 66. If this is undefined, then the MAX IP examines the siaddr

parameter in the DHCP ACK packet. If this is not defined, then the hostname parameter in the DHCP ACK

packet is used.

The DNS server IP address is defined by DHCP option 6.

The secondary DNS server IP address is defined by DHCP option 6.

The DNS domain is defined by DHCP option 15.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Keine Kommentare

ClearOne MAX EX Spezifikationen Seite 10