ClearOne AP10 Spezifikationen PDF herunterladen (Seite 7)

Technical or Setup Assistance

Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • http://www.gentner.com

Audio Perfect

10 Installation and Operations Manual Page 3

Rear-Panel Connectors

The AP10 back-panel connectors (See Figure 3, below) perform the following

functions:

1. Power. The AC power cord input is a NEMA type connector allowing 100–

240Vac, 50/60Hz.

2. G-Link In. This RJ45 connector is part of the G-Link RS485 LAN that provides

serial control and status of the hybrid. The first Gentner unit in the local G-Link

network must terminate G-LINK IN with a G-Link terminator. Other Gentner

units in the local G-Link network must connect the previous Gentner unit’s G-

LINK OUT to the next Gentner unit’s G-LINK IN connector.

3. G-Link Out. This RJ45 connector is part of the G-Link RS485 LAN that

provides serial control and status of the hybrid. The last Gentner unit in the local

G-Link network must terminate G-Link OUT with a G-Link terminator. Other

Gentner units in the local G-Link network must connect the following Gentner

unit’s G-Link IN to the previous Gentner unit’s G-LINK OUT connector.

4. Remote. This DB25 connector provides control and status of the AP10.

5. Transmit Input. This Pheonix

connector is for connecting transmit audio

(input) with the three-terminal Phoenix

push-on connector to the AP800. Note

that each position has three possible wiring positions: + (positive), - (negative)

and ò (ground).

6. Receive Output. This Pheonix

connector is for connecting receive audio

(output) with the three-terminal Phoenix

push-on connector from the AP800.

Note that each position has three possible wiring positions: + (positive), -

(negative) and ò (ground).

7. Line. This RJ11 connector provides connection of a standard analog telephone

line to the hybrid.

8. Set. This RJ11 connector allows connection to a standard telephone set. Tip

and ring from the phone line are present at this connector when the hybrid is in

its OFF state. Tip and ring from the phone line are not present at this point when

the hybrid is in its ON state.

Touch-Tone Dialing

Through the G-Link (and serial commands), the AP10’s touch-tone (DTMF)

dialing capability can be accessed. This allows outbound calls to be initiated by

the AP10 without requiring an external dialer or telephone set. This feature

continues to function after connection, enabling the user to issue tones for voice

mail/pager interaction.

Figure 3. AP10 back-panel connectors

REMOTE

5 6

TRANSMIT

INPUT

RECEIVE

OUTPUT

G-LINK

OUT

TELCO

LINE

SET

OLTAGE RANGE 100v-240V 2A

FREQUENCY 50Hz/60Hz

1 2 3 4 5 6 7 8 9 10 11 12 ... 29 30

Kommentare zu diesen Handbüchern

Keine Kommentare

ClearOne AP10 Spezifikationen Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung ClearOne AP10